Some shots of the mostly finished floor

Attaching the veneer to the hatch plywood took a little time, some quality wood glue, and a few clamps……

 

The glue of champions…..

Titebond III Ultimate exterior waterproof wood glue with an applicator brush. All you have to do to clean the brush is let the glue dry and scrape it clean with your fingernail.

After it was secured …..

Let the staining begin……it ultimately took about 8 coats for the Light parts (the holly strips) of pecan colored stain and four coats on the teak parts of Gunstock to match the existing floor.

 

first coats…..

Then it was on to stain the section of floor that had already been replaced.

As you can see, there is a decent amount of difference in the old vs new colors……

This is as close as I felt I could get them to match…..

All we need now is some trim pieces to finish it off….. But that’s next time…..

Published by

captainbrett@learntoliveaboard.com

I'm the average sailor...converted from a landlubber of course. While I was born with a love of the ocean it has evolved into a love of sailboats and other vessels that ply the open seas and connected waterways. I am probably like most of the people who (hopefully) will read our blog with the exception that we are now doing what we always dreamed of doing and I hope to help others do the same. I am NOT any of the following...a naval architect, a marine surveyor or connected commercially to any builder, distributor or boat sales organization. My opinions are generally my own, although influenced by many years of research.

6 thoughts on “Some shots of the mostly finished floor”

Leave a Reply to captainbrett@learntoliveaboard.com Cancel reply

Your email address will not be published.